1" Compression point Compression Points

1" Compression point Compression PointsThe compression point is the first part to go through the ground and is attached to the Master shaft or quick shaft. It breaks rocks, splits roots and other debris as it makes its way under the pavement and opens a hole larger than the shafts. It is actually 1 3 4" in diameter and will make a hole large enough to accommodate a 1" Sch 40 pipe with a coupling.

This case is Made in America By Pelican

1) The compression point is removed in the exit pit

It carries a full lifetime warranty

This will lock the point to the pipe so that it will not detatch when pulled backward

Digging Bar Hook

This part is used to insert a  1-1/4" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point

3/4 - 1" (PVC) Push Cap

This particular point is the Largest point that we sell

Then as the tool is driven through the ground the 3" drain cap actually pushes the pipe into the hole simultaneously as the Bullet Mole pierces the ground and advances under the pavement

This unique design combination allows for the female threaded end of the connector to be easily manuvered in order to quickly "FIND" the male thread of the shaft and be connected to it

Remove the point

After the Push Point is attached the pipe then this assembly is shoved into the hole made by the compression point