Plastics. Resins in the liquid state or as emulsions or dispersions. Determination of apparent viscosity using a single cylinder type rotational viscometer method Ingestion-build-132972

Plastics. Resins in the liquid state or as emulsions or dispersions. Determination of apparent viscosity using a single cylinder type rotational viscometer method Ingestion-build-1329721 Scope This document specifies a method of determining apparent viscosity of resins in a liquid state using a single cylinder type rotational viscometer. The method can be used for viscosity measurements in the range from 0,02 Pa s to 60 000 Pa s. This document is applicable to both Newtonian and non Newtonian liquids and the measured apparent viscosity depends on the velocity gradient to which the liquids are subjected during the measurement.

which are also unfamiliar to UK users but are not likely to be widely used in the UK

The electrostatic properties of most textile fabrics are dependent on the relative humidity and temperature of the atmosphere in which they are conditioned

NOTE 2 If third-party certification is involved

Forms of products Lists of EN Standards

— as a temporary format in all kinds of data transformation or manipulation

This test is only applied to single fibre cables and multiple fibre circular cables

Why should you use BS EN 186130 - Type LSA

High-pressure decorative laminates sheet consisting of decorative design surface layer(s) and core layers bonded together by an high pressure process

Electrical engineers/ Electronic engineers

by agreement between the purchaser and the supplier

BS EN 14358 also provides the acceptance procedure for the verification of a lot

This part of BS 1881 describes basic methods for the preparation of materials and the batching